Edge AWD V6-3.5L (2009)
-
Are the stoplamps illuminated?
Yes
REMOVE the jumper wire. INSTALL a new stoplamp switch. REFER to Stoplamp Switch See: Brake Light Switch/Service and Repair. TEST the
system for normal operation.
No
REMOVE the jumper wire. REPAIR circuit CCB08 (VT/WH) for an open. TEST the system for normal operation.
-------------------------------------------------
Pinpoint Test J: One Or More Stoplamps Are Inoperative
Stoplamps
Pinpoint Tests
Pinpoint Test J: One Or More Stoplamps Are Inoperative
Refer to Wiring Diagram Set 90, Turn Signal/Stop/Hazard Lamps for schematic and connector information. See: Diagrams/Electrical
Diagrams/Diagrams By Number
Normal Operation
When the brake pedal is applied, the stoplamp switch routes voltage to the Smart Junction Box (SJB) and the high mounted stoplamp through circuit
CCB08 (VT/WH).
When the SJB detects the brake pedal is applied, the SJB provides voltage to the LH and RH rear stoplamps through circuits CLS18 (GY/BN) and
CLS19 (VT/OG).
Ground for the LH and RH rear stoplamps is provided through circuits GD149 (BK/GY) and GD151 (BK/GN). Ground for the high mounted stoplamp
is provided through circuit GD149 (BK/GY).
B106E-B2047