Edge AWD V6-3.5L (2009)
Yes
GO to J9.
No
GO to J10.
-------------------------------------------------
J9 CHECK FOR VOLTAGE TO THE INOPERATIVE STOPLAMP USING THE CONNECTOR GROUND
-
Measure the voltage between the LH rear lamp C412-3, circuit CLS18 (GY/BN), harness side and the LH rear lamp C412-1, circuit GD149
(BK/GY), harness side; or between the RH rear lamp C415-3, circuit CLS19 (VT/OG), harness side and the RH rear lamp C415-1, circuit GD151
(BK/GN), harness side.
-
Is the voltage greater than 10 volts?
Yes
INSTALL a new bulb holder. CLEAR the DTCs. REPEAT the self-test.
No
REPAIR circuit GD149 (BK/GY) (LH rear stoplamp) or circuit GD151 (BK/GN) (RH rear stoplamp) for an open. TEST the system for normal
operation.
-------------------------------------------------
J10 CHECK THE SJB STOPLAMP OUTPUT CIRCUIT FOR AN OPEN
-
Disconnect: SJB C2280d.
-
Measure the resistance between the LH rear lamp C412-3, circuit CLS18 (GY/BN), harness side and the SJB C2280d-25, circuit CLS18 (GY/BN),
harness side; or between the RH rear lamp C415-3, circuit CLS19 (VT/OG), harness side and the SJB C2280d-26, circuit CLS19 (VT/OG),
harness side.
-
Is the resistance less than 5 ohms?
Yes
GO to J11.
No
REPAIR circuit CLS18 (GY/BN) (LH rear stoplamp) or circuit CLS19 (VT/OG) (RH rear stoplamp) for an open. CLEAR the DTCs. REPEAT the
self-test.
-------------------------------------------------
J11 CHECK FOR CORRECT SJB OPERATION
-
Disconnect all the SJB connectors.
-
Check for: