Edge AWD V6-3.5L (2009)
Alignment: Service and Repair
Camber Adjustment - Front
Camber Adjustment - Front
NOTE: Front camber is adjusted through the use of the upper strut plate. Rotating the upper strut plate 180 degrees will change the camber +0.5
degrees.
1. Using alignment equipment and the manufacturer's instructions, measure the camber.
2. Remove and discard the stabilizer bar link lower nut and disconnect the link from the lower arm.
-
To install, tighten the new nut to 90 Nm (66 lb-ft).
3. Remove and discard the 4 strut upper mounting plate nuts.
-
To install, tighten the new nuts to 30 Nm (22 lb-ft).
4. Using a suitable jack, raise the vehicle body enough to allow the front strut upper plate mounting studs to clear the frame.
5. NOTE: Rotating the upper strut plate 180 degrees will change the camber +0.5 degrees.
Rotate the upper mounting plate 180 degrees.
6. Recheck the front camber settings.
7. Check and, if necessary, adjust the front toe. For additional information, refer to Toe Adjustment - Front See: Toe Adjustment - Front.
