Edge AWD V6-3.5L (2009)
-
Is the resistance less than 5 ohms?
Yes
GO to G3.
No
REPAIR the circuit. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
G3 CHECK THE HS-CAN CIRCUITS BETWEEN THE SASM AND THE DLC FOR AN OPEN
-
Measure the resistance between the SASM C222-3, circuit VDB04 (WH/BU), harness side and the DLC C251-6, circuit VDB04 (WH/BU),
harness side.
-
Measure the resistance between the SASM C222-2, circuit VDB05 (WH), harness side and the DLC C251-14, circuit VDB05 (WH), harness side.
-
Are the resistances less than 5 ohms?
Yes
CONNECT the negative battery cable. GO to G4.
No
REPAIR the circuit. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
G4 CHECK FOR CORRECT SASM OPERATION
-
Disconnect the SASM connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the SASM connector and make sure it seats correctly.
-
Verify the concern is still present.
-
Is the concern still present?
