ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3069 > < Initial Inspection and Diagnostic Overview|Page 3067
Page 56
background image

Yes

If the vehicle is equipped with a Parking Aid Module (PAM), GO to U12.

If the vehicle is not equipped with a PAM, GO to U13.

No

GO to U43.

-------------------------------------------------
U12 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE PAM DISCONNECTED

-

Disconnect: PAM C4014 .

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to U13.

No

CONNECT the negative battery cable. GO to U44.

-------------------------------------------------
U13 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE ACM DISCONNECTED

-

Disconnect: Audio Control Module (ACM) C240b.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with an audio Digital Signal Processing (DSP) module, GO to U14.

If the vehicle is not equipped with an audio DSP module, GO to U15.

No

CONNECT the negative battery cable. GO to U45.

-------------------------------------------------
U14 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE AUDIO DSP MODULE
DISCONNECTED

-

Disconnect: Audio DSP Module C4348a.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

Initial Inspection and Diagnostic Overview|Page 3069 > < Initial Inspection and Diagnostic Overview|Page 3067