Edge AWD V6-3.5L (2009)
INSTALL the removed fuse. Go To Pinpoint Test F. See: Pinpoint Test F: The Headlamp Control Module (HCM) Does Not Respond To The Scan
Tool
No
INSTALL the removed fuse. GO to V13.
-------------------------------------------------
V13 VERIFY VEHICLE EQUIPMENT - SASM
-
Inspect the vehicle for an SASM.
-
Is the vehicle equipped with an SASM?
Yes
GO to V14.
No
GO to V15.
-------------------------------------------------
V14 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE SASM DISABLED
-
Disconnect: SJB Fuse 34 (5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test G. See: Pinpoint Test G: The Steering Angle Sensor Module (SASM) Does Not Respond To The
Scan Tool
No
INSTALL the removed fuse. GO to V11.
-------------------------------------------------
V15 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RCM AND THE OCSM DISABLED
-
Disconnect: SJB Fuse 46 (7.5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. GO to V16.
No
INSTALL the removed fuse. GO to V17.
-------------------------------------------------
V16 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RCM DISCONNECTED
-
Disconnect: RCM C310b.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the RCM. Go To Pinpoint Test C. See: Pinpoint Test C: The Restraints Control Module (RCM) Does Not Respond To The Scan Tool