Edge AWD V6-3.5L (2009)
instruction may result in serious personal injury.
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
NOTICE: When reusing liquid or vapor tube connectors, make sure to use compressed air to remove any foreign material from the connector
retaining clip area before separating from the tube or damage to the tube or connector retaining clip can occur. Apply clean engine oil to the
end of the tube before inserting the tube into the connector.
NOTICE: Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is essential that absolute cleanliness is
observed when working with these components or component damage can occur. Always plug or cap any open orifice or tube.
NOTICE: Do not use any tools. The use of tools may cause a deformity in the clip components which may cause fuel leaks.
1. If servicing a liquid fuel tube quick connect coupling, release the fuel system pressure. For additional information, refer to Fuel System Pressure
Release See: Fuel Filter/Fuel Pressure Release/Service and Repair.
2. Disconnect the battery ground cable.
3. NOTE: When reusing liquid or vapor tube quick connect couplings, make sure to use compressed air to remove any foreign material from the
retaining clip area before disconnecting from the tube.
Release the lock tab on the quick connect coupling.
4. Separate the quick connect coupling from the fitting.
Connect - Type VI
1. NOTE: Apply clean engine oil to the end of the tube and quick connect coupling O-ring seals.
Release the lock tab and install the quick connect coupling onto the fitting.
2. Apply the lock tab into the latched position.