Edge AWD V6-3.5L (2009)
5. NOTE: If the fuel tank is completely full, this step will lower the fuel level below the FP module mounting flange.
Attach the Fuel Storage Tanker to the fuel drain tube and drain one-eighth of a tank (approximately 3 gallons) of the fuel from a full tank.
6. Remove the rear seat.
7. Remove the 4 bolts and the FP module access cover.
8. NOTE: Clean the FP module connection, coupling, flange surface and the immediate surrounding area of any dirt or foreign material.
Disconnect the FP module electrical connector.
9. Disconnect the fuel tank jumper tube-to-FP module quick connect coupling.
10. NOTE: Place absorbent pads on the floor pan in the immediate area in case of fuel spills. Carefully remove the FP module from the vehicle to
avoid fuel spillage inside the vehicle.
Using the Fuel Tank Sender Unit Wrench, remove the FP module lock ring.
All-Wheel Drive (AWD) vehicles
11. NOTICE: The Fuel Pump (FP) module must be handled carefully to avoid damage to the float arm.
Carefully lift the FP module out of the fuel tank enough to access and disconnect the internal fuel tube-to-FP module quick connect coupling.
All vehicles
12. NOTE: The FP module will have residual fuel remaining internally, drain into a suitable container.
Completely remove the FP module from the fuel tank.
13. NOTE: Inspect the mating surfaces of the FP module flange and the fuel tank O-ring seal contact surfaces. Do not polish or adjust the O-ring seal
contact area of the fuel tank flange or the fuel tank. Install a new FP module or fuel tank if the O-ring seal contact area is bent, scratched or
corroded.
NOTE: Install a new lock ring if it is bent, damaged or corroded.
NOTE: To install, apply clean engine oil to the O-ring seal.
Remove the FP module O-ring seal.
14. NOTE: Make sure the alignment tab on the FP module and the fuel tank meet before tightening the FP module lock ring.
To install, reverse the removal procedure.
-
Install a FP module O-ring seal.
