Edge AWD V6-3.5L (2009)
6. Disconnect the side impact sensor electrical connector.
7. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
NOTE: Make sure the B-pillar and side impact sensor mating surfaces are clean and free of foreign material.
NOTE: Note the position of the side impact sensor locating tabs for correct installation.
Remove the bolt and side impact sensor.
-
To install, tighten to 11 Nm (97 lb-in).
8. To install, reverse the removal procedure.
9. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag
Systems/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General
Procedures.