Edge AWD V6-3.5L (2009)
7. NOTE: Outboard rear cross brace screws shown, inboard similar.
On the side with the affected OCS weight sensor bolt(s), remove the 2 rear cross brace screws.
8. NOTE: If any OCS weight sensor bolt nuts are removed, new OCS weight sensor bolt nuts must be installed.
Remove and discard the 2 OCS weight sensor bolt nuts from the affected side of the seat track rail with the OCS weight sensor bolt(s).
9. Remove the side plate with the OCS weight sensor bolt(s) from the seat track rail.
10. NOTICE: Do not overtighten the side plate with the Occupant Classification Sensor (OCS) weight sensor bolts to the bench or table.
Tighten only enough to compress the spring washer. Overtightening may damage the side plate or OCS weight sensor bolts.
Using a suitable tool, clamp the side plate to a bench or table to compress the spring washer on the affected OCS weight sensor bolt as shown.
11. NOTE: Note the position of the OCS weight sensor bolt, spring washer and retaining clip for installation.
Remove and discard the retaining clip from the affected OCS weight sensor bolt.