Edge AWD V6-3.5L (2009)
Removal and Installation
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure correct
retention of these parts.
NOTE: If replacing only the stabilizer bar bushings, proceed to Step 23 of this procedure.
All vehicles
1. NOTICE: Do not allow the steering column to rotate while the steering column shaft is disconnected, or damage to the clockspring may
occur. If there is evidence that the steering column has rotated, the clockspring must be removed and recentered. For additional
information, refer to Air Bag Systems.
NOTE: Use a steering wheel holding device (such as Hunter(R) 28-75-1 or equivalent). Using a suitable holding device, hold the steering wheel in
the straight-ahead position.
2. Remove the wheel and tire.
