Edge AWD V6-3.5L (2009)
17. NOTICE: Do not tighten the rear halfshaft nut with the vehicle on the ground. The nut must be tightened to specification before the
vehicle is lowered to the ground. Wheel bearing damage will occur if the wheel bearing is loaded with the weight of the vehicle applied.
NOTE: Apply the brake to keep the halfshaft from rotating.
Position the halfshaft in the hub and use the previously removed wheel hub nut to seat the halfshaft.
-
Tighten to 275 Nm (203 lb-ft).
-
Remove and discard the nut.
18. NOTICE: Install and tighten the new halfshaft nut to specification within five minutes of starting it on the threads. Always install a new
halfshaft nut after loosening or when not tightening within the specified time or damage to the components may occur.
Install a new inner wheel hub nut.
-
Tighten to 275 Nm (203 lb-ft).
19. Install a new outer wheel hub nut.
-
Tighten to 175 Nm (129 lb-ft).
All vehicles
20. Install the wheel and tire.