Edge AWD V6-3.5L (2009)
4. NOTE: Make sure that the manual pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body.
5. Inspect the manual pin to make sure it is correctly installed in the manual control valve. If it is not, pull the valve body off the transaxle case.
Correctly install the manual pin in the manual control valve and position the valve body in place.
6. Install the TR sensor detent spring and the bolts. Tighten the bolts in the sequence shown.
-
Tighten to 12 Nm (106 lb-in).
7. NOTICE: Do not handle the solenoid body in the leadframe area or by the screens of the solenoid body filter or damage to the solenoid
body can occur.
NOTICE: Use care not to break the alignment tabs when installing the solenoid body filter. Damage to the transaxle will occur if the
solenoid body is not correctly aligned.
