Edge AWD V6-3.5L (2009)
All vehicles
1. Install the selector lever and the selector lever bolts.
-
Tighten to 12 Nm (106 lb-in).
2. Connect the selector lever electrical connector.
3. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the selector lever cable bracket and listen for the selector lever cable retainer to click into place. Pull back on the selector lever cable to
make sure that the selector lever is locked into the selector lever cable bracket.
Install the selector lever cable in the selector lever housing.
4. Place the selector lever in REVERSE.
5. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
Disconnect the selector lever cable end from the manual control lever.