Edge AWD V6-3.5L (2009)
3. NOTE: Center console side trim cover removed for clarity.
Disconnect the Transmission Control Switch (TCS) electrical connector.
4. Remove and discard the selector lever knob trim covers by carefully prying out on the bottom front corners, and then pry out on the top front
corner and remove the covers.
5. NOTE: Inspect the knob body for damage. Install a new knob body if necessary.
Remove and discard the 2 selector lever knob screws. Remove the selector lever knob while routing the TCS electrical connector harness out of
the selector lever.
Installation
All vehicles
1. Route the TCS electrical connector harness through the selector lever and install the shift knob and 2 new screws. Loosely install both screws
before tightening.
-
Tighten to 2 Nm (18 lb-in).
2. NOTE: Be sure that the selector lever knob bezel is correctly installed on the selector lever knob.
Install new selector lever knob trim covers.