Edge AWD V6-3.5L (2009)
19. Remove the 2 nuts and the transmission fluid cooler thermal bypass valve.
Installation
1. Position the transmission fluid cooler thermal bypass valve in place and install the 2 nuts.
-
Tighten to 9 Nm (80 lb-in).
2. Inspect the transmission fluid cooler tube backing rings and seals for damage and install new backing rings or seals if necessary. Lubricate the
transmission fluid cooler tube seals with clean transmission fluid and install the backing rings and seals on the transmission fluid cooler tubes.
3. Position the 2 transmission fluid cooler tubes on the transaxle and tighten the 2 transmission fluid cooler tube fittings.
-
Tighten to 25 Nm (18 lb-ft).
4. Install 2 new transmission fluid cooler tube bolts.
-
Tighten to 9 Nm (80 lb-in).