Edge AWD V6-3.5L (2009)
-
One-half of the grease must be installed in the joint and the remainder placed in the boot.
8. NOTICE: Do not let the roller bearings fall or damage to the component may occur.
Position the CV housing on the CV joint.
9. Install the retaining ring.
10. Position the inboard halfshaft boot and clamps.
-
Position the boot in the housing groove.
-
Position the boot clamps.
11. NOTE: RH halfshaft shown on top, LH halfshaft on bottom.
Set the halfshaft assembled length to specifications. For additional information, refer to Specifications.
1. Measure the entire assembly length.
2. Push in or pull out on the inner joint as necessary to adjust the halfshaft assembled length.
3. Hold the inner joint to prevent the assembled length from changing and insert a small flat-blade screwdriver between the boot and the joint to
equalize the pressure.
