Edge AWD V6-3.5L (2009)
2. Using the Constant Velocity Joint Boot Clamp Installer, install the 79.6 mm (3.13 in) boot clamps on the large end of the boot.
3. Install the small clamp on the small end of the boot.
4. NOTICE: Install a new circlip every time the halfshaft is removed from the axle or damage to the component may occur.
NOTICE: Start one end of the circlip in the groove and work the circlip over the halfshaft and into the groove to prevent the circlip from
overexpanding or damage to the clamp may occur.
Install a new retainer circlip.
5. Position the small clamp on the interconnecting shaft before installing the boot.
6. Position the boot on the interconnecting shaft.
7. Install the inner race and the retainer snap ring.
8. Install the outer race with 8 balls.
9. Insert the assembly in the housing.
10. Install the retaining ring.