Edge AWD V6-3.5L (2009)
8. Remove the 2 bolts from the electrical harness grommet to the door.
9. Using the speaker hole for access, release the clip on the harness from the inside to disconnect the harness from the door.
10. Unclip the weatherstrip and feed through the wiring harness between the weatherstrip and door.
11. Remove the 3 door latch screws.
-
To install, tighten to 12 Nm (106 lb-in).
12. Remove the access plug from the latch side of the door and remove the outside door handle reinforcement screw.
13. Remove the outside door handle.
14. Remove the exterior door handle reinforcement screw.
-
To install, tighten to 8 Nm (71 lb-in).
15. If equipped, remove the door keypad.
16. Remove the 9 door module bolts and remove the rear door module, transfer parts as necessary.
-
To install, tighten to 9 Nm (80 lb-in).