Edge AWD V6-3.7L (2011)
3. With a wax pencil, mark the relationship of the rear subframe to the underbody at the mounting locations.
4. Remove the muffler and tailpipe assembly.
5. Disconnect the LH and RH wheel speed sensor connectors.
6. NOTE: All-Wheel Drive (AWD) shown, Front Wheel Drive (FWD) similar.
Remove the connector from the front of the subframe and position aside.
7. NOTICE: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose may occur.
Remove the 4 bolts (2 each side) from the rear hub spindle-to-brake caliper.
-
To install, tighten to 70 Nm (52 lb-ft).
