Edge FWD V6-3.5L (2007)
12. Disconnect the electrical connectors from the powertrain control module (PCM).
13. Remove the evaporative purge valve and bracket from the center of the lower cowl panel grille and set aside.
14. Remove the 5 bolts and 3 nuts from inside the lower cowl grille panel.
-
To install, tighten to 9 Nm (80 lb-in).
15. Remove the bolt from the lower cowl panel-to-front of dash
-
To install, tighten to 20 Nm (15 lb-ft).
16. Remove the lower cowl grille panel and PCM from the vehicle.
Upper and lower cowl grille panel
17. CAUTION: Incorrect installation of the lower/upper cowl panel grille may cause damage to the windshield. Make sure the cowl panel
grille clips are located under the windshield prior to installation.
To install, reverse the removal procedure.
-
Transfer the components as necessary.
-
Adjust the pivot arms.