Edge FWD V6-3.5L (2007)
Sunroof / Moonroof Motor: Service and Repair
Roof Opening Panel Motor - Shades
ROOF OPENING PANEL MOTOR - SHADES
Removal and Installation
CAUTION: The roof opening panel shade motor contains ceramic magnets that may fail at any time if cracked. Any roof opening panel shade
motor that has been dropped onto a hard surface during removal or installation should be replaced with a new motor.
1. Remove the headliner.
2. Disconnect the electrical connector.
3. NOTE: During installation, it may be necessary to rotate the motor clockwise or counterclockwise for the gear teeth to set into the drive cable
correctly.
Remove the 3 motor screws and the motor assembly.
-
To install, tighten to 5 Nm (44 lb-in).
4. To install, reverse the removal procedure.
-
Initialize the roof opening panel motor(s).