Edge FWD V6-3.5L (2007)
Part 2
Disassembly and Assembly
WARNING: Never remove the recliner-to-backrest frame bolts or the recliner-to-floor anchor assembly bolts. If these bolts are removed, and
a specially designed fixture is not used for reassembly, the recliner will bind and the seat back can fail in a crash. Failure to follow these
instructions may result in serious personal injury to the vehicle occupant.
All seats
1. Remove the 60 percent seat.
2. Remove the 60 percent cushion.
3. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
Remove the bolt and separate the safety belt retractor belt and buckle anchor from the riser.
-
To install, tighten to 65 Nm (48 lb-ft).