Edge FWD V6-3.5L (2007)
20. From the back, invert the backrest trim cover up and over the backrest frame and remove the backrest trim cover and backrest foam pad.
21. CAUTION: Use care when separating the backrest trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn
from the backrest foam pad.
NOTE: If a new heater mat or foam pad with heat are needed, the parts will already be assembled from the factory. There is no need to remove
the heater mat from the foam pad.
Remove the backrest trim cover from the backrest foam pad in the following sequence.
1. Invert the backrest trim cover in an inside out fashion to the wire in the backrest trim cover attached to the clips in the backrest foam pad.
-
Separate the hook-and-loop strips.
2. Separate the backrest trim cover wire from the clips in the backrest foam pad.
3. Remove the backrest trim cover.
-
Feed the safety belt retractor belt and safety belt buckle through the backrest trim cover and backrest foam pad.
22. Remove the backrest foam pad.
23. Release the retainers and remove the back panel.
24. Remove the safety belt retractor nut, pin-type retainer under the safety belt and the safety belt retractor.
-
To install, tighten to 50 Nm (37 lb-ft).
25. Remove 2 screws and the outboard upper side shield.
26. Remove 2 screws and the inboard upper side shield.
27. Remove 2 screws and the outboard lower side shield.
28. Remove 2 screws and the inboard lower side shield.
29. Separate the recliner cable casing at both ends from the recliners.
30. Remove the recliner cable in the following sequence.
1. Turn the cable end so the tab aligns with the slot in the lever and separate the cable at one end.
2. Turn the cable end so the tab aligns with the slot in the lever and separate the cable at the other end.
-
Remove the recliner cable.
Seats with power fold
31. Remove the power fold motor in the following sequence.
1. Remove the 2 screws from the power fold motor.
2. Slide the cable casing out of the recliner.
3. Turn the cable end so the tab aligns with the slot in the lever and separate the cable.
4. Remove the power fold motor.
Seats with heat
32. Disconnect the electrical connector, remove the screw and the heated seat module.
All seats
33. To assemble, reverse the disassembly procedure.
-
Check the active restraint system for correct operation.
-
Verify the safety belt retractor operates without excessive effort or binding.
-
Make sure the LATCH is accessible to the occupant.
Seat Backrest - Rear, 40 Percent
SEAT BACKREST - REAR, 40 PERCENT
