Edge FWD V6-3.5L (2007)
Seat Cover: Service and Repair
Seat Cushion Cover
Front
SEAT CUSHION COVER - FRONT
Special Tool(s)
Special Tool(s)
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Position the seat to access all the seat track-to-floor bolts and the safety belt retractor belt anchor nut.
2. Depower the SRS.
3. Remove the front seat.
4. Remove the front seat cushion.
5. Release the cushion trim cover retainers from the cushion frame and remove the cushion trim cover and cushion foam pad.
6. CAUTION: Use care when separating the cushion trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn
from the cushion foam pad.
NOTE: A new heater mat will come assembled on a new foam pad.
Remove the cushion trim cover in the following sequence.
1. Separate the hook-and-loop strips.
2. Separate the cushion trim cover wire retainer from the clips in the cushion foam pad.
-
For vehicles with climate controlled seats (CCS), on assembly make sure the CCS manifold is in place before snapping the cushion trim
cover wire retainer back into the cushion foam pad.
3. Remove the cushion trim cover.
7. To install, reverse the removal procedure.
8. Install the front seat cushion.
-
For correct front passenger seat cushion wire harness routing, refer to Seat Wire Harness Routing-Front Passenger Cushion. See: Locations
9. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
10. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.
40 Percent
SEAT CUSHION COVER - REAR, 40 PERCENT
