Edge FWD V6-3.5L (2007)
SEAT CUSHION - REAR, 60 PERCENT
Disassembly and Assembly
1. Remove the 60 percent seat.
2. Remove the 60 percent seat cushion.
3. Remove the 2 bolts and the kneeling assembly.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Release all the cushion trim cover-to-cushion frame retainers and remove the cushion foam pad and cushion trim cover.
5. CAUTION: Use care when separating the cushion trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn
from the cushion foam pad.
Remove the cushion trim cover in the following sequence.
1. Feed the heater mat wire harness and electrical connectors back through the cushion trim cover (if equipped).
2. Release the hook-and-loop strips.
3. Separate the cushion trim cover wire retainer from the clips in the cushion foam pad and remove the cushion trim cover.