Edge FWD V6-3.5L (2007)
Seat Heater: Service and Repair
Seat Cushion Thermo-Electric Device
SEAT CUSHION THERMO-ELECTRIC DEVICE
Special Tool(s)
Special Tool(s)
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
The cushion thermo-electric device (TED) filter is detachable from the TED assembly housing from underneath the seat cushion.
All seats
1. Position the seat to access all the seat track-to-floor bolts and the safety belt retractor belt anchor nut.
2. Depower the SRS.
3. Remove the front seat.
4. Remove the front seat cushion.
5. Release the cushion trim cover retainers from the cushion frame and remove the cushion trim cover and cushion foam pad.
6. Remove the 3 cushion thermal electric device (TED)-to-cushion frame screws.
7. Remove the cushion TED-to-climate control seat cushion adapter screw and remove the TED.
8. To install, reverse the removal procedure.
-
For correct front passenger seat cushion wire harness routing, refer to Seat Wire Harness Routing-Front Passenger Cushion. See: Locations
9. Install the front seat cushion assembly.
10. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
11. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.