Edge FWD V6-3.5L (2007)
Seat Track: Service and Repair
Seat Track
Special Tool(s)
Removal
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
To install a new occupant classification module or an occupant classification sensor (OCS) weight sensor bolt, refer to the appropriate procedure
in Air Bag Systems.
All seats
1. Position the seat to access all the seat track-to-floor bolts and the safety belt retractor belt anchor nut.
2. Depower the SRS.
3. Remove the front seat.
4. Remove the front seat backrest.
5. Separate the seat wire harness main feed electrical connector(s) from the seat track brackets.
6. Disconnect the safety belt buckle pretensioner and safety belt buckle switch electrical connectors. Separate any retainers holding the wire harness
or electrical connectors to the seat track and safety belt buckle and pretensioner.
7. Disconnect all the seat track motor electrical connectors and separate any retainers holding the wire harness or electrical connectors to the seat
track (if equipped).
Driver seat
8. Disconnect the seat track position sensor and separate any retainers holding the wire harness or electrical connectors to the seat track.
9. Disconnect the driver seat module (DSM) electrical connectors and separate any retainers holding the wire harness to the seat track (if equipped).
Passenger seat with manual seat track
10. NOTE: Rear inboard occupant classification sensor (OCS) weight sensor bolt protection bracket shown, others similar.
Separate the wire harness from the OCS weight sensor bolt protection brackets, remove the 4 OCS weight sensor bolt protection bracket screws
and remove the 4 OCS weight sensor bolt protection brackets.