Edge FWD V6-3.5L (2007)
Seat Heater Switch: Service and Repair
Seat Control Switch
Front
SEAT CONTROL SWITCH - FRONT
Special Tool(s)
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. If possible, position the seat all the way up and center the seat in the front door opening.
2. Depower the supplemental restraint system (SRS).
3. Remove the seat control switch in the following sequence.
1. Remove the safety belt retractor belt anchor nut cover.
2. If equipped with manual recline, release the clip and remove the manual recline handle.
3. If equipped with manual lumbar, pull and remove the manual lumbar handle.
4. Remove the cushion side shield screw(s).
5. Slide the cushion side shield up in the rear to release the retainer.
6. Slide the cushion side shield forward to disengage the retainer.
7. Release the cushion side shield clips and separate the seat control switch.
8. Disconnect the seat control switch electrical connector and remove the switch.
4. To install, reverse the removal procedure.
5. Repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
6. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.
Rear
SEAT CONTROL SWITCH - REAR SEAT
