Edge FWD V6-3.5L (2007)
3. NOTE: Master cylinder pressure bleeder adapter tools are available from various manufacturers of pressure bleeding equipment. Follow the
manufacturer's instructions when installing the adapter.
Install the bleeder adapter to the brake master cylinder reservoir and attach the bleeder tank hose to the fitting on the adapter.
4. Place a box-end wrench on the RH rear disc brake caliper bleeder screw. Attach a rubber hose to the RH rear disc brake caliper bleeder screw and
submerge the free end of the hose in a container partially filled with clean, specified brake fluid.
5. Open the valve on the bleeder tank.
6. Loosen the rear disc brake caliper bleeder screw. Leave the bleeder screw open until clear, bubble-free brake fluid flows into the container, then
tighten the rear disc brake caliper bleeder screw and remove the rubber hose.
^
Tighten to 8 Nm (71 inch lbs).
7. Continue bleeding the rest of the system, going in order from the LH rear disc brake caliper to the RH front disc brake caliper, ending with the LH
front disc brake caliper.
8. Close the bleeder tank valve and remove the tank hose from the adapter and remove the adapter.
9. Fill the brake master cylinder reservoir with clean, specified brake fluid and install the cap.
Manual
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION: Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder
reservoir filled with clean, specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
