Edge FWD V6-3.5L (2007)
Brake Caliper: Service and Repair
Brake Caliper Support Plate
Brake Caliper Support Plate
Brake Caliper Support Plate
Removal and Installation
1. Remove the brake disc shield.
2. Remove the 2 parking brake cable-to-support plate bolts, disconnect the parking brake cable from the lever and position the cable aside.
^
To install, tighten to 23 Nm (17 ft. lbs).
3. Remove the 2 dust boot shield bolts and the dust shield.
^
To install, tighten to 10 Nm (89 inch lbs).
4. Remove the dust boot.
5. To install, reverse the removal procedure.