Edge FWD V6-3.5L (2007)
Brake Master Cylinder: Removal and Replacement
Brake Master Cylinder
Material
Removal and Installation
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Remove the air cleaner and air cleaner outlet tube. For additional information, refer to Fuel Delivery and Air Induction.
2. Remove the battery and battery tray. For additional information, refer to Battery.
3. Disconnect the brake fluid level switch electrical connector.
4. Using a suitable suction device, remove the brake fluid from the brake master cylinder reservoir.
