Edge FWD V6-3.5L (2007)
Remove the stop lamp switch.
2. CAUTION: The brake booster check valve must be disconnected from the brake booster (prior to removing the master cylinder) or the
master cylinder seal may be drawn into the brake booster.
Disconnect the brake booster check valve from the brake booster to deplete the residual vacuum in the brake booster.
3. Remove the brake master cylinder.
4. CAUTION: Make sure that the vacuum hose assembly is routed correctly so it does not make contact with surrounding components.
Disconnect the manifold vacuum hose assembly from the brake booster.
5. Disconnect the vacuum hose and wire harness from the studs and position aside.
6. Remove the 2 pushpin fasteners and the lower instrument panel cover.
7. Remove the brake booster push rod pin and clip and disconnect the push rod from the brake pedal.
8. Remove the 4 brake booster nuts.
^
To install, tighten to 23 Nm (17 ft. lbs).
9. Remove the brake booster.
10. To install, reverse the removal procedure.
11. Check the brake booster for correct operation.
