Edge FWD V6-3.5L (2007)
37. Using the special tool, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
^
Stage 1: Tighten to 120 Nm (89 ft. lbs).
^
Stage 2: Loosen one full turn.
^
Stage 3: Tighten to 50 Nm (37 ft. lbs).
^
Stage 4: Tighten an additional 90 degrees.
38. Install the accessory drive belt tensioner and the 3 bolts.
^
Tighten to 10 Nm (89 inch lbs).
39. Install the power steering pump and the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs).
40. NOTE: Installation of new seals is only required if damaged seals were removed during disassembly of the engine.
NOTE: Spark plug tube seal installation shown, variable camshaft timing (VCT) seal installation similar.