Edge FWD V6-3.5L (2007)
NOTE: Spark plug tube seal installation shown, variable camshaft timing (VCT) seal installation similar.
Using the special tools, install new VCT solenoid and/or spark plug tube seals.
18. NOTE: If the valve cover is not installed and the fasteners tightened within 5 minutes, the sealant must be removed and the sealing area
cleaned. To clean the sealing area, use silicone gasket remover and metal surface prep. Follow the directions on the packaging. Failure to follow
this procedure can cause future oil leakage.
Apply a 8 mm (0.31 inch) bead of silicone gasket and sealant to the engine front cover-to-RH cylinder head joints.
19. Using a new gasket, install the RH valve cover, bolt and the 10 stud bolts.
^
Tighten in the sequence shown to 10 Nm (89 inch lbs).