Edge FWD V6-3.5L (2007)
Oil Pressure Sender: Service and Repair
Engine Oil Pressure (EOP) Switch
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the cooling fan assembly. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
3. Disconnect the engine oil pressure (EOP) switch electrical connector.
4. Remove the EOP switch.
^
To install, tighten to 18 Nm (13 ft. lbs).
5. To install, reverse the removal procedure.
^
Apply thread sealant with PTFE to the EOP switch threads prior to installation.
