Edge FWD V6-3.5L (2007)
46. Using the special tool, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
^
Stage 1: Tighten to 120 Nm (89 ft. lbs).
^
Stage 2: Loosen one full turn.
^
Stage 3: Tighten to 50 Nm (37 ft. lbs).
^
Stage 4: Tighten an additional 90 degrees.
47. Install the accessory drive belt, tensioner and the power steering belt.
48. Fill the engine with clean engine oil.
49. Connect the battery ground cable. For additional information, refer to Battery.
50. Evacuate and recharge the air conditioning system. For additional information, refer to Heating and Air Conditioning.