Edge FWD V6-3.5L (2007)
13. Install the engine front cover.
14. Install the RH cylinder block drain plug or, if equipped, the block heater.
^
Tighten the cylinder block drain plug to 20 Nm (15 ft. lbs).
^
Tighten the block heater to 41 Nm (30 ft. lbs).
15. NOTE: Make sure that the block heater wiring is routed and secured away from rotating or hot components, or damage to the wiring can occur.
If equipped, connect the block heater electrical connector and install the heat shield.
16. Install the LH cylinder block drain plug.
^
Tighten to 20 Nm (15 ft. lbs) plus an additional 180 degrees.
