Edge FWD V6-3.5L (2007)
Air Inlet Mode Door Actuator Linkage
Removal and Installation
NOTE: It is not required to install the new air inlet door linkage parts included in the air inlet mode door actuator service part kit if only the mode door
actuator requires replacement and the linkage parts are not broken or binding.
Air inlet mode door actuator and linkage
1. Disconnect the glove compartment damper from the glove compartment.
2. Remove the glove compartment.
3. Remove the 3 air inlet mode door actuator screws.
4. Disconnect the air inlet mode door actuator electrical connector.
5. Remove the air inlet mode door actuator.
6. Manually operate and inspect the air inlet mode door and air inlet mode door linkage for incorrect placement or damage.
Air inlet mode door linkage only
7. Remove the air inlet mode door intermediate lever screw.
8. Remove the air inlet mode door intermediate lever.