Edge FWD V6-3.5L (2007)
11. CAUTION: Place absorbent pads on the floor pan in the immediate area in case of fuel spills. Carefully remove the fuel pump (FP)
module from the vehicle to avoid fuel spillage inside the vehicle.
Using the special tool, remove the FP module lock ring retainer.
All wheel drive (AWD) vehicles
12. CAUTION: The fuel pump (FP) module must be handled carefully to avoid damage to the FP module and/or float arm.
Carefully lift the FP module out of the fuel tank enough to access and disconnect the fuel tank crossover tube-to-FP module quick connect
coupling.
All vehicles
13. CAUTION: The fuel pump (FP) module will have residual fuel remaining internally, drain into a suitable container.
Completely remove the FP module from the fuel tank.
14. CAUTION:
-
Inspect the mating surfaces of the fuel pump (FP) module flange and the fuel tank O-ring seal contact surfaces. Do not polish or
adjust the O-ring seal contact area of the fuel tank flange or the fuel tank. Install a new FP module or fuel tank if the O-ring seal
contact area is bent, scratched or corroded.
-
Make sure to install a new fuel pump (FP) module O-ring seal. Install a new lock ring if it is bent, damaged or corroded.
NOTE: To install, apply clean engine oil to the O-ring seal.
Remove the FP module O-ring seal.
15. NOTE: Make sure the alignment tab on the fuel pump (FP) module and the fuel tank meet before tightening the FP module lock ring.
To install, reverse the removal procedure.
