Edge FWD V6-3.5L (2007)
Exploded View
Removal and Installation
1. Disconnect the mass air flow (MAF) sensor electrical connector.
2. Loosen the clamp and disconnect the air cleaner outlet pipe from the air cleaner.
-
To install, tighten to 5 Nm (44 lb-in).
3. Remove the air cleaner bolt.
-
To install, tighten to 9 Nm (80 lb-in).
4. NOTE: No tools are needed to remove the air cleaner assembly. Removal should be carried out using hands only.
Separate the 2 air cleaner feet from the rubber grommets and remove the air cleaner assembly.
5. NOTE:
-
Make sure that the 2 air cleaner feet are seated into the rubber grommets under the air cleaner assembly.
-
The air cleaner outlet pipe should be securely sealed to prevent unmetered air from entering the engine.
To install, reverse the removal procedure.