Edge FWD V6-3.5L (2007)
Fuse Block: Customer Interest
Electrical - MIL ON/No Crank/No Start/DTC's Set
TSB 10-1-8
02/01/10
PCM - BATTERY JUNCTION BOX (BJB) - POSSIBLE
MIL ON WITH MULTIPLE DTCS, NO CRANK/NO
START, DRIVABILITY SYMPTOMS
FORD:
2007 Edge
LINCOLN:
2007 MKX
This article supersedes TSB 7-16-5 to remove the production build date and TSB 7-17-9 to update the Service Procedure.
ISSUE
Some 2007 Edge and MKX vehicles may exhibit concerns that results in no crank/start, buck/jerk, lack/loss of power and/or malfunction indicator lamp
(MIL) with one or more diagnostic trouble codes (DTCs) present. This could be caused by a poor fuse terminal fit, loose or unseated wire terminal
connection at the Battery Junction Box (BJB) located near the battery under the hood.
ACTION
If loose and/or unseated wiring terminals for fuses
and relays are found in the BJB, follow the Service
Procedure steps to correct the condition.
SERVICE PROCEDURE
1. Disconnect the vehicle battery.
2. Open the BJB top cover. (Figure 1)
3. Check for loose fuse connections in the BJB at fuse positions 30, 31, 32, 33, and 34. If poor terminal fit is present, note those fuse cavities for Step 6.