Edge FWD V6-3.5L (2007)
of the wheel.
NOTE: The sensor has raised markings indicating how to position the sensor.
Remove the adhesive tape liner from the cradle and position the sensor and cradle into the wheel drop well 180 degrees from the valve stem.
4. Install the tapered end of the strap through the opening of the cradle on the hinge side of the sensor. This will position the worm gear on the
locking clip side of the sensor.
5. CAUTION: Steel wheels have a "high spot" along their circumference. Make sure the strap is positioned in the lowest spot possible for
correct sensor and cradle retention.
NOTE: Keep the strap parallel with the wheel flange while tightening the worm gear.
Position the worm gear 13-26 mm (0.5-1.0 inch) away from the sensor and tighten the worm gear.
^
Tighten to 3 Nm (27 inch lbs).
6. CAUTION: The sensor, cradle and strap can be damaged by incorrect tire mounting or dismounting. Mount the tire only as instructed.
Install the tire onto the wheel.
7. NOTE: A new tire pressure sensor is shipped in an off mode (or battery saver mode) and must be turned on before it can be trained. To turn the
sensor on, install it on a wheel, mount the tire and inflate the tire to the recommended inflation pressure. Wait at least 2 minutes, then continue
with the sensor training procedure.
Train the tire pressure sensor(s).
