Edge FWD V6-3.5L (2007)
a. Tug on the underside wires to determine the unseated terminal location. (Figures 7 and 8)
NOTE
THIS MAY REQUIRE SOME LEVEL OF HARNESS REMOVAL FROM THE VEHICLE MOUNTING LOCATIONS TO ADEQUATELY
ACCESS THE LEADS ON THE UNDERSIDE OF THE BJB BLOCK.
11. Any circuits that do not offer any resistance during the tugging operation should be reseated using the Push-Click-Tug method.
a. Push the terminal back into the cavity.
b. Listen for an audible click to assure lock engagement.
c. Tug on the lead to insure a proper seat occurred.
12. Once all the BJB circuits have been verified as seated, proceed to the next steps.
13. Install and lock the BJB block back into the splash shield.
14. Install the light gray retainer.
15. Reinstall all the mini fuses, relays and diodes back into their specific locations.
a. Make sure all the relays are replaced in the proper orientation.
16. Close the BJB cover.
17. Reconnect the vehicle battery cable.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
100108A
2007 Edge, MKX: Follow
0.6 Hr.
