Edge FWD V6-3.5L (2007)
2. CAUTION: Make sure the retainer clip clicks into place when installing.
Depress the locking mechanism until it is flush with the quick connect coupling housing and is fully seated onto the tube.
3. Rotate the primary locking tab on the retainer clip to the closed position.
4. Pull on the quick connect coupling and the tube to make sure it is securely fastened.
Disconnect - Type III
WARNING:
-
Do not carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable vapors
are always present and can ignite. Failure to follow these instructions may result in personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may
result in personal injury.
CAUTION:
-
If the liquid or vapor tube is damaged (torn, holes or delaminated), a new tube assembly must be installed. Do not use aftermarket
sleeving. Do not re-adhere loose sleeving material.
-
When reusing liquid or vapor tube quick connect couplings, make sure to use compressed air to remove any foreign material from the
connector locking tab area before separating the quick connect coupling from the tube. Apply clean engine oil to the end of the tube
before inserting the quick connect coupling onto the tube.
-
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is therefore essential that absolute cleanliness
is observed when working with these components. Always install blanking plugs to any open orifices or tubes.
1. If servicing a liquid fuel tube quick connect coupling, release the fuel system pressure.
