Edge FWD V6-3.5L (2007)
Throttle Body: Service and Repair
THROTTLE BODY
Removal and Installation
CAUTION: The throttle body must be removed from the vehicle to be cleaned. Do not hold the throttle plate open with any object that could
scratch the bore or plate while servicing or cleaning the throttle body.
1. Remove the air cleaner outlet pipe.
2. Disconnect the electronic throttle control electrical connector.
3. Remove the 4 bolts and the throttle body (TB).
-
Discard the TB gasket.
-
To install, tighten to 10 Nm (89 lb-in).
4. NOTE: Install a new TB gasket.
To install, reverse the removal procedure.
