Edge FWD V6-3.5L (2007)
Removal and Installation
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to the appropriate scan tool. This
information must be downloaded into the new module after installation.
1. NOTE: This step is necessary only if the DSM is being replaced.
Upload the module configuration information from the DSM into the scan tool.
2. NOTE: If the driver seat can be moved to a high enough position, the DSM screws can be removed without removing the driver seat.
If necessary, remove the driver seat.
3. Remove the 2 screws.
4. Disconnect the 4 electrical connectors and remove the DSM.
