Edge FWD V6-3.5L (2007)
pawl actuating rod from the TR sensor and remove the TR sensor.
Installation
1. Install the TR sensor.
1
Position the park pawl actuating rod in the TR sensor.
2
Install the TR sensor in the transaxle case.
2. Using the special tool, install a new TR sensor locking pin.
3. NOTE: Make sure that the manual lever pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body, the TR sensor detent spring and the 10 bolts.
Tighten the bolts in the sequence shown.
^
Tighten to 12 Nm (9 ft. lbs).
