Edge FWD V6-3.5L (2007)
4. Connect the large RCM electrical connector.
-
Using the connector position assurance lever, pivot it toward the RCM, drawing the connector into the RCM.
-
Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
5. Connect the small RCM electrical connector.
6. Install the inner floor console support bracket.
7. Install the 4 bolts (2 each side) to the inner floor console support bracket.
-
Tighten to 12 Nm (9 lb-ft).
8. Install the screws to the inner floor console bracket support-to-floor instrument panel.
-
Tighten to 12 Nm (9 lb-ft).
9. Install the selector lever cable in the selector lever housing.
10. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever
cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable end to make sure that the cable end is correctly installed.
Connect the selector lever cable end to the floor shifter.
11. Attach the electrical connectors to the front inner floor console support bracket.
12. Install the floor console.
13. Repower the supplemental restraint system (SRS). Do not prove out the SRS at this time.
14. When installing a new RCM, carry out the steps necessary to complete programmable module installation (PMI).
15. Prove out the SRS as follows:
Turn the ignition switch from ON to OFF. Wait 10 seconds, then turn the ignition switch back to ON and visually monitor the air bag indicator
with the air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn OFF. If an air
bag SRS fault is present, the air bag indicator will:
-
fail to light.
-
remain lit continuously.
-
flash at a 5 Hz rate (RCM not configured).
The air bag warning indicator might not light until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the RCM to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault exists, a
chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and
repaired.
