Edge FWD V6-3.5L (2007)
the spring washer. Overtightening may damage the side plate or OCS weight sensor bolts.
Using a suitable tool, clamp the side plate to a bench or table to compress the spring washer on the affected OCS weight sensor bolt as shown.
13. NOTE: Note the position of the OCS weight sensor bolt, spring washer and retaining clip for installation.
Remove and discard the retaining clip from the affected OCS weight sensor bolt.
14. Release the clamp and remove the OCS weight sensor bolt and spring washer from the side plate.
Installation
All OCS weight sensor bolt(s)
1. CAUTION: Do not overtighten the side plate with the occupant classification sensor (OCS) weight sensor bolts to the bench or table.
Tighten only enough to compress the spring washer. Overtightening may damage the side plate or OCS weight sensor bolts.
Position the spring washer and OCS weight sensor bolt in the side plate. Then clamp the side plate to a bench or table to compress the OCS weight
sensor bolt spring washer.
2. NOTE: Make sure the OCS weight sensor bolt retaining clip is seated fully in the OCS weight sensor bolt groove underneath the OCS weight
sensor O-ring seal.
Install the OCS weight sensor bolt retaining clip.
3. Remove the clamp and the side plate from the bench or table.
